É um emblema tridimensional que pode ser anexado ao tanque de combustível.. Como um ponto Attachment.
O corpo tem Material: Plástico é adotado, Plaqueamento é aplicado na superfície da parte do personagem.
Emblema Fita dupla face para exterior forte é colada na parte de trás.
Existem dois tipos de revestimento: prata e ouro, dois tipos de LargeSmall são atribuídos a cada quantidade: 2pc. Definido por quatro, totalizando Quantidade: 1 Conjunto.
[Ad Vise]
Nós estamos adotando o assento forte da adesão, assim que verific a posição bem antes de colar o trabalho
Se umidade, óleo, poeira e cera estiverem presentes, a adesão será extremamente baixa, por isso, limpe e desengraxe as superfícies de adesão completamente.
Ambiente com baixa temperatura ambiente (5 graus ou menos) A fim de reforçar a força de adesão inicial, por favor, trabalhe depois de aquecer ligeiramente o assento adesivo.
Depois de colar, por favor, pressione bem a partir do topo para fortalecer a adesão.Por favor, não lave ou chuva durante 1 ou 2 dias após a colagem.
This is a three-dimensional emblem that can be attached to the gas tank, side cover, etc. as a one-point accessory.
The body is made of plastic, and the surface of the letters is plated.
Strong exterior double-sided tape is attached to the back of the emblem.
Plating is available in silver and gold.Two large and two small, total 4 pieces per set.
[Advice]
The strong adhesive sheet is used, so please check the position of the adhesive sheet carefully before installation.
If there is water, oil, dust, or wax on the surface, the adhesive strength will become extremely poor, so be sure to thoroughly clean and degrease the adhesive surface.
When working in a low temperature environment (below 5 degrees Celsius), warm up the adhesive sheet a little before working in order to strengthen the initial adhesive strength.
After pasting, please press well from the top to strengthen the adhesive force.Please do not wash your car or drive in the rain for 1 or 2 days after application.