Um must-have para quem está tendo problemas para colocar o pé na série Z1 / Z2 / KZ1000 !.
O couro do assento é cortado para fazer a esponja do assento para Slim e Slim, então não há excesso desnecessário e nenhum padrão de assento será deslocado para baixo.
Se você escalar, você pode ver que é muito mais estreito do que o NORMAL. Você está preocupado em andar de motocicleta se não tiver certeza de onde está?
Livre-se dessas coisas e aproveite os Zs ao máximo !.
Especifique o engate de montagem diferente para Z1 (tipo de barra única) e KZ1000 (Forma de U) ..
1. Experimente colocar a cadeira Slim no local de onde removeu a cadeira Normal.. Se conseguirmos colocá-lo lá sem problemas.
2. Fixe o SeatFitting à frente e atrás do Suporte da Estrutura para a abertura lateral.
Neste momento, afrouxe os parafusos de ajuste e instale-os temporariamente.. tão
→ Se não fechar corretamente, ou se levantar, ou se atingir a tampa traseira com muita força, pode ser necessário ajustar a altura da conexão.
→ Se a instalação foi bem-sucedida, mude para 3 ..
3. Instale a almofada de borracha atrás do assento.. tão
→ Se você encontrar um problema como o assento está distorcido ou levantado após sentar, você precisa ajustar a almofada de borracha.
Você precisa ajustar a altura e assim por diante para atingir a média.
→ Se não é um problema, é isso !.
Engate tipo Z1 / Z2 (tipo de barra única) (Ver foto) e o tipo em forma de U para a série KZ1000
It is a necessity for the person who has trouble with the footing in Z1 / Z2 / KZ1000 series.
The seat leather is cut for the molding of the Slim & Slim seat sponge, so there is no unnecessary excess or shifting of the seat pattern downwards.
When you ride on it, you can see that the width is much narrower than stock.If you don't feel comfortable with your feet, you won't feel comfortable riding the bike, will you?
Please solve these problems and enjoy Z to the fullest.
The mounting hitch for Z1 (single bar type) and KZ1000 series (U-shaped) are different, so please specify.
1. Please put the slim seat on the place where the stock seat was removed.If I can get it on without a problem
Install the seat fitting to the front and rear of the frame bracket for horizontal opening.
At this time, loosen the fitting mounting bolts and leave them temporarily installed.therefore
If there is a problem such as it doesn't close properly, it lifts up and closes, or it hits the tail cowl tightly, you need to adjust the height of the fitting.
If the installation is successful, go to step 3.
3. Please install the rubber cushion on the back of the seat.therefore
If the seat is distorted or lifted, the rubber cushion needs to be adjusted.
It is necessary to adjust the height so that it hits on average.
If there is no problem, you are done.