*Este produto é aproximadamente 65mm atrás e 3mm mais baixo em altura do que o cabo do stock.
*A largura total é de -5mm no fim da alavanca do stock(Largura total:±20mm/altura total:±40mm) Não é necessária qualquer alteração estrutural.
*Não há necessidade de mudar a mangueira/harness/fios para este produto, mas se estiver preocupado com isso, por favor mude a mangueira de travão para o comprimento apropriado. Por favor, ajuste a tensão do fio do eixo devido à mudança no manuseamento.
*Existe um erro na espessura da tinta neste produto. Quando se vira o lado do eixo, pode ser monótono. Neste caso, é necessário ajustar o lado da manga do acelerador do guiador, raspando com uma lima.
*As marcas de socos neste produto são apenas para referência. Por favor, ajuste a posição da pega ao seu gosto.
*Há um caso em que o buraco da caixa de interruptores deste produto está ligeiramente desalinhado. Nesse caso, pode ser necessário modificá-lo alargando o buraco. Se é uma pessoa que é finista quanto à instalação de parafusos, ou se está nervoso quanto ao custo e processo de mão-de-obra, recomendamos-lhe que consulte previamente a loja Honda Dream.
*Há um caso em que há uma mudança de especificação da mercadoria pela conveniência do fabricante. Por favor, compreendam.
[Size*] W: 710 H: 100 R: 200 L: 130
[Handle diameter] 1 inch (25.4mm)
*W (Overall width) H (Height) R (Amount of pullback) L (Clamp section straight) Unit (mm)
*This product is approximately 65mm back and 3mm lower in height than the stock handle.
*Overall width is -5mm at the end of the stock lever.(Full width: ±20mm / height: ±40mm) No structural changes are required.
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.Adjust the tension of the axle wire due to the changes in handling.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the throttle sleeve side of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.If you are a person who is finicky about bolt-on installation, or if you are nervous about the labor cost and process, it is recommended that you consult with your HONDA Dream shop beforehand.
*There may be changes in product specifications due to the manufacturer's reasons.