- First-class products are always better, but I thought that a measuring instrument of this price would be sufficient. It is more reliable than no management. There are many comparison videos on Youtube...consulte Mais informação
- I am satisfied with the well made product, but I have old eyes and it is hard for me to see the memory.Otherwise, it is OK.consulte Mais informação
- Not bad, but the lock part is sometimes subtle and difficult to use.consulte Mais informação
- I can use it for daily maintenance without any problem. The price is reasonable. The long handle makes it easy to apply force and easy to use.consulte Mais informação
- I bought this for Stem Nut and Wheel nut of my car.The Torque wrench is a fairly inexpensive part of the Torque wrench, but it is not excessive or inadequate.consulte Mais informação
- This is used for areas where the Torque is Large. Measurement is also possible.Very easy to use.consulte Mais informação
- I bought a Torque wrench because I didn't have one before.Recently, I had more and more chances to tighten the Rear Axle Nut for chain tension adjustment, etc. I did not know how tight I should tighte...consulte Mais informação
- I am not sure if the Torque is accurate or not. I am a little worried about that because it is made in Taiwan...but there is one great advantage.It is bigger, heavier, and longer than other Torque wre...consulte Mais informação
- I purchased this product to use when changing Tire.It was just the right length, and I personally liked it just fine.consulte Mais informação
- I purchased this for Torque management of Axle Shaft installation.The wide range of the Torque measurement range could be used for Caliper Mounting Bolt.The most Large is 210 Nm, so it is indeed Large...consulte Mais informação
- It is large and can be used for changing tires on cars. It is not suitable for engine work.consulte Mais informação
- The content of the instruction manual of the attachment was difficult to understand, but I was able to understand it by the explanation written in the box. I think that the cost is good.consulte Mais informação
- I always ignore Torque when I install Parts and I was worried about it.But for a cheap price, Case is solid.I thought that the time to use it would come sooner or later.consulte Mais informação
- It is 28N-m, so less than 3kg, and Torque is the smallest value around here.Familiar ones are like Oil's Drain bolt.This area is OK, but delicate bolts such as Cylinder head cannot be managed.Because ...consulte Mais informação
- Orthodox pre-set type, easy to use, up to 200N type, big and heavy, but well made. The only difference is the Torque value, Quantity:Set is a little difficult to get used to. Because the basic tick va...consulte Mais informação
- Used for Z900rsChain adjustment, tightened at 110kn.consulte Mais informação
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING